SAE J 2654
Hardness measurements are used as a quality control check of the consistency of formulation and processing of brake linings. This hardness method is nondestructive.NOTE?This method is not a measure of friction level.The hardness and the range of hardness are characteristic of each formulation; therefore, the acceptable values and ranges must be established for each formulation and may be affected by processing.NOTE?The hardness of sintered powder metal lining is usually determined with Rockwell superficial hardness equipment. (See ASTM B 347)
- This product replaces:SAE J 2654 - Hardness of Brake Lining
SAE J 2654
SAE J 2654
Cart
(empty)
New products
- BS PD ISO/TS 7127:2023
- BS PD ISO/TS 9491-1:2023
- BS PD IEC TS 62898-3-4:2023
- BS PD ISO/TS 24665:2023
- BS PD ISO/TR 14644-21:2023
- BS PD ISO/IEC TS 30105-9:2023
- BS PD ISO/IEC TS 27560:2023
- BS 8636:2023
- BS PD ISO/TR 9839:2023
- BS PD IEC TR 63222-100:2023
- BS PD ISO/TR 37178:2023
- BS PD IEC TS 62998-3:2023
- BS PD IEC TS 61496-5:2023
- BS PD ISO/TR 15377:2023
- BS PD IEC TR 63415:2023
- BS PD ISO/IEC TR 7052:2023
- BS PD CLC/TS 50600-5-1:2023
- BS PD IEC TS 61400-30:2023
- BS PD ISO/TS 11686:2023
- BS PD CEN/TS 17959:2023
- BS PD ISO/PAS 24644-1:2023
- BS PD ISO/TR 9464:2023
- BS PD ISO/PAS 18940-1:2023
- BS PD ISO/TR 12770:2023
- BS PD IEC TS 62915:2023
