ASTM D6138-23
ASTM D6138-23 Standard Test Method for Determination of Corrosion-Preventive Properties of Lubricating Greases Under Dynamic Wet Conditions (Emcor Test)
standard by ASTM International, 05/01/2023
Full Description
1.1 This test method covers the determination of corrosion-preventive properties of greases using grease-lubricated ball bearings under dynamic wet conditions. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.Cart
(empty)
New products
- BS PD ISO/TS 7127:2023
- BS PD ISO/TS 9491-1:2023
- BS PD IEC TS 62898-3-4:2023
- BS PD ISO/TS 24665:2023
- BS PD ISO/TR 14644-21:2023
- BS PD ISO/IEC TS 30105-9:2023
- BS PD ISO/IEC TS 27560:2023
- BS 8636:2023
- BS PD ISO/TR 9839:2023
- BS PD IEC TR 63222-100:2023
- BS PD ISO/TR 37178:2023
- BS PD IEC TS 62998-3:2023
- BS PD IEC TS 61496-5:2023
- BS PD ISO/TR 15377:2023
- BS PD IEC TR 63415:2023
- BS PD ISO/IEC TR 7052:2023
- BS PD CLC/TS 50600-5-1:2023
- BS PD IEC TS 61400-30:2023
- BS PD ISO/TS 11686:2023
- BS PD CEN/TS 17959:2023
- BS PD ISO/PAS 24644-1:2023
- BS PD ISO/TR 9464:2023
- BS PD ISO/PAS 18940-1:2023
- BS PD ISO/TR 12770:2023
- BS PD IEC TS 62915:2023
